2000 PSD Monitor Mode ??

mo_smoke · New Member Joined: Sep 20, 2007 Posts: 23 Location: NH

I connected up all the inputs and went to check the trans perameters and found that it was set for a 10 cyl motor (It has a 6cyl cummins) and I am using a 4-pulse per rev tach pick-up and the peak rpm needs to be set at 4000 rpm, and also noticed that the driveshaft rpm is set for 16 pulses per rev and the base file in the download sect is 6 pulses per rev. The 4x4 ratio needs to be 2.72. The truck has 4.30 gears and 37" tires so I need the parameters for that also (or I can send you the current tcu file).

Tim

2000 F-250 w/ cummin s 12valve Diesel
4r100 trans / 4wheel drive.

Russ · PCS Employee Joined: May 12, 2004 Posts: 278

Tim,
The 4WD low ratio only applies to transmissions where the speed sensor is located on the output of the transfer case. We have plenty of 4R100 calibrations for diesels. Send an email to support@ptcs.us or give us a call and we can email you calibration that will be much closer to your application to get you started.

Russ

mo_smoke · New Member Joined: Sep 20, 2007 Posts: 23 Location: NH

Russ,

How is that last revesion of the software doing with those two combined items, I called a couple of weeks ago and you were out and the guy that answered the tech line asked the software poeple and they were waiting to confirm with you.

Thanks in advance.

Tim
_________________
Pics of the truckMy Pics

Russ · PCS Employee Joined: May 12, 2004 Posts: 278

Tim,
It is on the list of things to do and won't take long to add. However our software guys are tied up on a new test stand for our production military controller. It will be another week or so before they can get back to it.

Russ

mo_smoke · New Member Joined: Sep 20, 2007 Posts: 23 Location: NH

No problem, I just wanted to make sure it didn't fall through the cracks. Thanks again.

Tim
_________________
Pics of the truckMy Pics