Can't program cal b?

92bird · Newbie Joined: Jan 16, 2008 Posts: 5

I have the PCS controller on a 98 Ford 4R70W. I have everything hooked up correctly. When I flip the switch, cal b does indicate and my indicator light illuminates. No problems there..

But the calibration B section in the calibration section remains grayed out.

I tried copying cal a to cal b and it seemed to do it, but calibration B tables are still grayed out. I can only edit calibration A tables.

I enabled cal b both by the switch and by test mode. It still is grayed out.

Any ideas?

Jeramie

Russ · PCS Employee Joined: May 12, 2004 Posts: 286

Jeramie,
To correct the problem go to Transmission setup from the menus at the top and select transmission mode. Change the transmission mode from 5R110 to Normal and you will then be able to access Cal B.

Russ