Posted: Fri May 25, 2007 8:39 pm Post subject: Speed 1 & 2 inputs
I've just downloaded v.16 to fix a glitch with selecting a 4 cyl. engine for my RPM setup.
I'm now able to select 4 cyl. from the drop down menu, but upon running the engine, I don't get any RPM feedback when viewing the monitor feature. I've triple checked the wire in my factory harness and on the XFC harness (pin 12 - orange/black) and am certain that I have it hooked up correctly. I've set up the trigger level at 0.94 and set the filter value at 60 per the manual and still nothing. I've played around with these values and it didn't result in anything. Both pullup enabled and disabled were also tried.
I'm experiencing the same no signal problem with my VSS input. I've tapped into one of my ABS wheel speed sensors and tried the trigger and filter value settings highlighted in the manual but show no change speed while viewing the monitor screen.
Please let me know if this is a software issue as I'm very confident that I'm not doing anything wrong wiring wise on my end.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in
